Generic pnp monitor overclock Pc#
Generic pnp monitor overclock tv#

May be something like adaptive sync or in your monitor specs going by the specs I posted below the setting may be call no-sync. Often they don't call itВ FreeSyncВ in their menus either. Thanks again.Many Feesync monitors come with Freesync disabled. Mate, you have a PayPal link? Would love to throw you a few bucks. Monitors generally don't need CTA modes of refresh, right? That's why I can get 90 Hz smooth motion, no issues, on my laptop and Dell Desktop monitor?

Generic pnp monitor overclock Pc#

Those, though, are dedicated PC monitors and are not televisions.Д¬ool, this is what I figured. Notable for mention, of course, is that on my Dell 32' at my workstation PC and on my gaming laptop, these CRU refresh rates work just fine. In theory, these native refresh rates are great for games like Valheim and Horizon: Zero Dawn that won't run at 120 Hz on any hardware but could benefit from a nice intermediary frame rate between 60 and 120. Both exhibit a micro-stuttering of sorts that's clearly visible both at the desktop and in game. (04-15-2021 01:39 AM)ToastyX Wrote: (04-12-2021 03:00 AM)XAGMNINETY Wrote: However, my CRU values of 75 and 90 Hz, unsupported refresh rates, do not work as intended.

Generic pnp monitor overclock tv#

The TV probably skips frames with non-CTA modes. Or is it just a TV incompatibility? No worries if that's the case, but I'd like a working 75 or 90 on my OLED. Those, though, are dedicated PC monitors and are not televisions.ДЄm I missing something? Are my timing inputs incorrect, or is there some specific setting to get exactly 75 or 90 Hz refresh rates? Keep in mind that I'm just putting 75 and 90 as flat numbers in the refresh rate slot of CRU, and I understand that most supported refresh rates have decimals. (04-12-2021 03:00 AM)XAGMNINETY Wrote: However, my CRU values of 75 and 90 Hz, unsupported refresh rates, do not work as intended. My thick 28AWG cable arrived today, which seems to be able to power the monitor at 115Hz, sadly not 120, but it still completely artifacts with 'tv-static bars' at 55Hz or below, even with the new cable.Д®dit: FreeSync works (I tested it, must have been cable issue because screwing tight made everything suddenly work) between 30 and 50 Hz time to fine tune. Secondly, I did not try the HDMI block while the monitor was overclocked, since I did read through ALOT of forum posts before giving up and asking here However even at 60Hz I got artifacting with the HDMI block, and thinking it was some sort of bandwidth issue I tried downclocking the monitor - which it hates. What happens below 55 Hz? That monitor should be able to handle lower refresh rates.ДЇirst of all, thank you for taking your time to answer me, Im very grateful. That monitor uses dual-link DVI, and HDMI is single-link, so it can only handle half the bandwidth. Could this be an issue with my cable, or perhaps the graphics card? I have tried many combinations except for a different cable and gpu. Underclocking the monitor below 55Hz also results in problems.

I can overclock easily to 96Hz, but as soon as I add the HDMI block in CRU it has a lot of artifacting.